Frequently Asked Questions
Q: Do I need to use an adhesion promoter with this primer?
✅ No. This product is designed for direct-to-metal (DTM) application and provides corrosion protection and quality adhesion without additional promoter.
Q: How many coats should I apply?
✅ Apply 2 coats – one light/medium coat followed by one medium/wet coat with proper flash times between.
Before You Begin
🔴 Important Precautions:
-
Always wear a respirator, gloves, and appropriate protective equipment.
-
Shake the can vigorously for at least 2 minutes before use.
-
Ideal application temperature: 68°F (20°C) with 35–75% humidity.
-
Apply in a well-ventilated area, not in direct sunlight.
-
If working in very dry conditions, add humidity by lightly misting the air or using a humidifier.
Application Steps
1. Surface Preparation
-
Clean and prep metal or existing surfaces with 120–220 grit sandpaper.
-
Remove all loose scale, dirt, and grease.
-
Clean with a solvent cleaner.
-
For plastic parts, use a waterborne/plastic cleaner.
2. Spray Application Instructions
-
Hold can 8–10 inches from the surface.
-
Apply 2 coats:
-
First coat: light/medium, allow at least 5 minutes flash time.
-
Second coat: medium/wet coat.
-
-
Allow 20 minutes flash time before applying seam sealer, body filler, or topcoat.
-
Overcoating window:
-
May be coated over with filler, basecoat, or urethane primer after 45 minutes–1 hour air dry or 30 minutes with IR heat/baking.
-
For recoating beyond 48 hours, surface must be scuffed.
-
3. Drying and Curing
-
Out of dust: ~30–60 minutes.
-
Handle time: 30 minutes – 1 hour.
-
Full cure: 14–21 days (continues curing under fillers, basecoats, and urethane primers).
4. Cleanup
-
Use Acetone or Xylene to remove overspray from unwanted areas.
-
Turn can upside down and spray until only clear gas exits to clean nozzle.
-
Dispose of rags and applicators safely by laying flat to dry before disposal.
Characteristics
-
Direct-to-metal primer, no adhesion promoter required.
-
Provides excellent corrosion protection and adhesion.
-
Can be topcoated with fillers, primers, or basecoats.
-
Heat resistance up to 300°F (150°C).
-
Storage stability: 24 months.
Need Further Assistance? No Worries!
📧 Contact us at help@poppyspatina.com for additional support.