Shine Juice
Application Instructions
- Wash the surface using dish soap; removing as much dirt, grit, and oxidation as possible before applying the "Shine Juice".
- Apply “Shine Juice” to the panel by wiping on evenly.
- Allow to dry for 20-30 minutes.
- Wipe off excess “Shine Juice” with a dry rag/towel
When applied correctly you will get a matte/satin sheen on the surface. This is an oil based product so it can be removed from the surface with dish soap or Degreaser.
**CLEAN UP & DISPOSAL**
*Risk of Fire From Spontaneous Combustion Exist With This Product*
**Soiled rags, waste, and other oily materials can cause spontaneous combustion fires if not disposed of properly.*
1) Spread out all soiled materials outside to dry by flattening them out to their full size in a well ventilated area for 24 hours at temperatures above 40 degrees F, or (2) Wash them thoroughly with water and detergent and rinse. Repeat until you have removed all oil from all clothes, tools, rags, or any other materials. Make certain all wash and rinse water is disposed of properly.”*
***Use At Your Own Risk***
FORMULATED FOR APPLICATION BY TRAINED PROFESSIONALS
USING PROPER EQUIPMENT UNDER CONTROLLED USE CONDITIONS.
Read all warnings and cautions elsewhere on label.
Warranty: Because the condition of use and application are beyond our control. We assume no liability for any product failure or damage.